NEW FRONTIER ARMORY 80% LOWER COMPLETION JIG AR-15 / AR-9
YES! This jig works with New Frontiers C-4, C-9, C-45, C-5, and G-15 80% Lowers and all other "Mil-Spec" 80% lowers on the market! This kit may not work with "Billet" that have unique dimensions or offsets.
The New Frontier Armory Complete 80% Jig Kit is all you need to complete the final machining process to turn your 80% AR-15 Receiver into a working stripped lower receiver. You will need to provide the following drill bits: 3/8”, 5/32”, 1/8”, 7/16”.
-Instructions to complete using a drill press
-Instructions to complete using a milling machine
-Left and Right side fixture plates / vice jaws
-Three top plate templates
-All hardware necessary to secure jig and top plate
- MADE IN THE USA by hard working American men and women
Because of the importance of the alignment pin, it will be an extremely tight fit in the bolt catch detent and spring hole. You may have to drill the hole in your lower larger or sand down the pin for an easier removal but you should keep a very snug fit. The hole in the lower may feel smaller after different finishing methods such as tumbling, blasting, coating, etc.
NOTE: ALL BATFE / NFA RULES APPLY — New Frontier Armory LLC is not responsible for any city, county, state, or federal laws that you do not comply with when using this jig to finish your receiver.